Premier™ PRSD1100M PRS-Series Mono Class D Amplifier -OS (See New PRSD1200M)

Product Code: PRS-D1100M Price: Check Latest Premier™ PRSD1100M Premier™ PRS Mono Class D Amplifier with 1200 Watts Max. Power Premier™ PRS Mono Class D Amplifier with 1200 Watts Max. Power 600 Watts Continuous Power Variable Crossover (40~240Hz, LPF) Selectable Bass Boost with Wired Bass Remote Suggested Price: $400.00 Rock the House with Premier PRS Amplifiers Round out your PRS system with the Premier PRS-D1100M, designed to complement the new PRS-D4100F and PRS-D2100T amplifiers. Drive your subwoofers with authority with this powerful and clean-sounding amplifier. Externally Bridgeable The units are externally bridgeable and permit two separate amplifiers to be joined together as one, doubling the power to a single woofer or voice coil. Best of all, no special cable is required - a simple RCA cable and proper setting of the Sync mode will get this. Multi-Amplifier Synchronization System (MASS) Pioneer's proprietary Multi-Amplifier Synchronization System (MASS) technology allows one amplifier (the master) to control the settings of other amplifiers when two or more amps are “strapped” together. Especially important for multi-amplified systems, this powerful Pioneer technology eliminates the need to adjust each amplifier gain separately. Variable Crossover (40~240Hz, LPF) For added flexibility, the variable crossover lets you set the levels at which higher-frequency signals will be filtered out, so that the remaining lower-frequency signals get sent to your sub(s). Where they belong. This optimizes your system's efficiency and delivers the best possible sound quality. You can adjust it continuously between 40 to 240Hz. Selectable Bass Boost with Wired Bass Remote So you're in the driver's seat going 65mph and you want to fine-tune the bass boost. But the amp's out of reach, way in the back. What are you supposed to do — pull over, get out, and run around to the trunk? That's why the PRS-D1100M comes with a wired bass remote. It's set at 50Hz, ideal for tuning in some more thump from your subwoofers. And because this is selectable bass boost, you can set the level at 0dB, 6dB, or 12dB, whichever sounds best to you. Speaker Level Inputs What, you DON'T own a Pioneer headunit? Well, we won't hold it against you. In fact we'll even help you build onto your system. The PRS-D1100M's speaker level inputs allow you to connect your OEM unit (or any unit that doesn't have the typical RCA-type inputs) without having to buy add-on adapters. Features: Bridgeable   Channel # Capability: 1   Class-D Design   MOSFET Output Section   Screw-Type Speaker Terminals   Balanced Isolator Input Circuit   RCA Inputs: 2 Channel (Gold Plated)   Speaker Level Input: Yes   Input Level Control: Hi-Volt (400mV~6.5V)   Built-in Crossover: LPF   Crossover Frequency Range: 40~500Hz, -12dB/Oct. Bass Level Control: 50Hz, 0/6/9/12dB, with Remote   Specifications: Peak Music Power: 1200 Watts   Number of Channels: 1   Load Impedance Capability: 2~8 Ohm   Continuous Power (4 ohm): 400 Watts x 1   Continuous Power (2 ohm): 600 Watts x 1   Frequency Response: 10Hz ~ 240Hz   Total Harmonic Distortion: 0.5%   Signal-to-Noise Ratio: 92 dB CEA 2006 Specifications   Output Power (4 Ohm, <=1% THD): 400 Watts x 1   Output Power (2 Ohm, <=1% THD): 600 Watts x 1 Signal to Noise (1 Watt into 4 Ohms): 66 dBA   Approximate Dimensions: Width: 11-15/16"   Height: 2-3/16"   Depth: 7-11/16"